Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide 17
19 Utility Settings
I/O Interface Settings 283
Setting up the Oscilloscope's LAN Connection 284
To establish a LAN connection 285
Stand-alone (Point-to-Point) Connection to a PC 286
File Explorer 287
Setting Oscilloscope Preferences 289
To choose "expand about" center or ground 289
To disable/enable transparent backgrounds 290
To load the default label library 290
To set up the screen saver 290
To set AutoScale preferences 291
Setting the Oscilloscope's Clock 292
Setting the Rear Panel TRIG OUT Source 292
Performing Service Tasks 293
To perform user calibration 294
To perform hardware self test 296
To perform front panel self test 296
To display oscilloscope information 296
To display the user calibration status 297
To clean the oscilloscope 297
To check warranty and extended services status 297
To contact Agilent 297
To return the instrument 298
Configuring the [Quick Action] Key 298
20 Web Interface
Accessing the Web Interface 302
Browser Web Control 303
Real Scope Remote Front Panel 304
To Next Page
Loading...
Need help?
General
