268 Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide
17 Save/Recall (Setups, Screens, Data)
3 Press the Settings softkey.
In the File Settings Menu, you have these softkeys and options:
• Setup Info — when enabled, setup information (vertical, horizontal,
trigger, acquisition, math, and display settings) is also saved in a
separate file with a TXT extension.
• Length — sets the number of data points that will be output to the
file. For more information, see "Length Control" on page 269.
• Alb Format — Available ALB serial formats include:
• Default
• CAN
• I2C
• LIN
• UART/RS232
• SPI (2 Wire Serial)
• SPI (3 Wire Serial)
• SPI (4 Wire Serial)
When you choose any ALB format other than Default, waveforms
from the analog channels (if displayed) are also digitized and
displayed as digital waveforms. The analog channel's trigger level
determines the point at which the voltage is considered a logic 1 or
0.
If you connect your serial bus signals to the oscilloscope as shown in
the following table, the bus/signal names in the Agilent Logic
Analyzer application will be correct. Otherwise, you must re- map the
signals in the Agilent Logic Analyzer application.
To Next Page
Loading...
Need help?
General
