FlexRay Triggering and Serial Decode 23
Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide 359
2 In the Search Menu, press the Search softkey; then, turn the Entry knob
to select the serial bus (Serial 1 or Serial 2) on which the FlexRay
signals are being decoded.
3 In the Search Menu, press Search for; then, select from these options:
• Frame ID — Finds frames with the specified ID. Press the Frame ID
softkey to select the ID.
• Cycle number (+ Frame ID) — Finds frames with the specified cycle
number and ID. Press the Frame ID softkey to select the ID. Press
the Cycle # softkey to select the number.
• Data (+ Frame ID + Cycle number) — Finds frames with the specified data,
cycle number, and frame ID. Press the Frame ID softkey to select the
ID. Press the Cycle # softkey to select the number. Press the Data
sofkey to open a menu where you can enter the data value.
• Header CRC Error — Finds cyclic redundancy check errors in headers.
• Frame CRC Error — Finds cyclic redundancy check errors in frames.
• Errors — finds all errors.
For more information on searching data, see "Searching Lister Data" on
page 126.
For more information on using the [Navigate] key and controls, see
"Navigating the Time Base" on page 58.
To Next Page
Loading...
Need help?
General
