Agilent Technologies InfiniiVision 3000 - To Select Generated Waveform Types and Settings; 17, Save;Recall (Setups, Screens, Data

251
Agilent InfiniiVision 3000 X-Series Oscilloscopes
User's Guide
s1
16
Waveform Generator
To select generated waveform types and settings 251
To edit arbitrary waveforms 255
To output the waveform generator sync pulse 259
To specify the expected output load 259
To use waveform generator logic presets 260
To add noise to the waveform generator output 261
To restore waveform generator defaults 261
A waveform generator is built into the oscilloscope. It is enabled by
Option WGN or the DSOX3WAVEGEN upgrade. The waveform generator
gives you an easy way to provide input signals when testing circuitry with
the oscilloscope.
Waveform generator settings can be saved and recalled with oscilloscope
setups. See Chapter 17, “Save/Recall (Setups, Screens, Data),” starting on
page 263.
To select generated waveform types and settings
1 To access the Waveform Generator Menu and enable or disable the
waveform generator output on the front panel Gen Out BNC, press the
[Wave Gen] key.
When waveform generator output is enabled, the [Wave Gen] key is
illuminated. When waveform generator output is disabled, the [Wave
Gen] key is off.
The waveform generator output is always disabled when the instrument
is first turned on.