298 Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide
19 Utility Settings
To return the instrument
Before shipping the oscilloscope to Agilent Technologies, contact your
nearest Agilent Technologies sales or service office for additional details.
Information on contacting Agilent Technologies can be found at:
"www.agilent.com/find/contactus"
1 Write the following information on a tag and attach it to the
oscilloscope.
• Name and address of owner.
• Model number.
• Serial number.
• Description of service required or failure indication.
2 Remove accessories from the oscilloscope.
Only return accessories to Agilent Technologies if they are associated
with the failure symptoms.
3 Package the oscilloscope.
You can use the original shipping container, or provide your own
materials sufficient to protect the instrument during shipping.
4 Seal the shipping container securely, and mark it FRAGILE.
Configuring the [Quick Action] Key
The [Quick Action] key lets you perform common, repetitive actions by
pressing a single key.
To configure the [Quick Action] key:
1 Press [Utility] > Quick Action > Action; then, select the action that should be
performed:
• Off — disables the [Quick Action] key.
• Quick Measure All — displays a popup containing a snapshot of all the
single waveform measurements. The Source softkey lets you select the
waveform source (which also becomes the source selection in the
Measurement Menu). See Chapter 14, “Measurements,” starting on
page 213.
To Next Page
Loading...
