141
Agilent InfiniiVision 3000 X-Series Oscilloscopes
User's Guide
s1
10
Triggers
Adjusting the Trigger Level 143
Forcing a Trigger 143
Edge Trigger 144
Edge then Edge Trigger 146
Pulse Width Trigger 147
Pattern Trigger 150
OR Trigger 153
Rise/Fall Time Trigger 155
Nth Edge Burst Trigger 156
Runt Trigger 158
Setup and Hold Trigger 160
Video Trigger 161
USB Trigger 173
Serial Trigger 175
A trigger setup tells the oscilloscope when to acquire and display data.
For example, you can set up to trigger on the rising edge of the analog
channel 1 input signal.
You can adjust the vertical level used for analog channel edge detection by
turning the Trigger Level knob.
In addition to the edge trigger type, you can also set up triggers on
rise/fall times, Nth edge bursts, patterns, pulse widths, runt pulses, setup
and hold violations, TV signals, USB signals, and serial signals (if option
licenses are installed).
You can use any input channel or the "External Trigger Input" on
page 182 BNC as the source for most trigger types.
To Next Page
Loading...
Need help?
General
