Web Interface 20
Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide 307
Remote Programming with Agilent IO Libraries
While the SCPI Commands applet window lets you enter and remote
programming commands, remote programming for automated test and data
acquisition is typically done using the Agilent IO Libraries, which are
separate from the instrument's web interface.
The Agilent IO Libraries let a controller PC communicate with Agilent
InfiniiVision oscilloscopes via their USB, LAN (when the LAN/VGA option
module is installed), or GPIB (when the GPIB option module is installed)
interfaces.
The Agilent IO Libraries Suite connectivity software to enables
communication over these interfaces. You can download the Agilent IO
Libraries Suite from "www.agilent.com/find/iolib".
Information about controlling the oscilloscope through remote commands
is contained in the Programmer's Guide, which is included on the
documentation CD supplied with this oscilloscope. You can also access this
document on the Agilent web site.
For more information about connecting to the oscilloscope, refer to the
Agilent Technologies USB/LAN/GPIB Interfaces Connectivity Guide. For a
printable electronic copy of the Connectivity Guide, direct your Web
browser to "www.agilent.com" and search for "Connectivity Guide".
Save/Recall
You can save setup files, screen images, waveform data files, or mask files
to your PC via the oscilloscope's web interface (see "Saving Files via the
Web Interface" on page 307).
You can recall setup files, reference waveform data files, or mask files
from your PC via the oscilloscope's web interface (see "Recalling Files via
the Web Interface" on page 309).
Saving Files via the Web Interface
To save setup files, screen images, waveform data, Lister data, or mask
files to your PC via the oscilloscope's web interface:
To Next Page
Loading...
Need help?
General
