Save/Recall (Setups, Screens, Data) 17
Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide 271
To save Lister data files
Lister data files can be saved to an external USB storage device.
1 Press [Save/Recall] > Save > Format; then, turn the Entry knob to select
Lister data file.
2 Press the softkey in the second position and use the Entry knob to
navigate to the save location. See "To navigate storage locations" on
page 272.
3 Press the Settings softkey.
In the File Settings Menu, you have these softkeys and options:
• Setup Info — when enabled, setup information (vertical, horizontal,
trigger, acquisition, math, and display settings) is also saved in a
separate file with a TXT extension.
4 Finally, press the Press to Save softkey.
A message indicating whether the save was successful is displayed.
To save reference waveform files to a USB storage device
1 Press the [Save/Recall] key.
2 In the Save/Recall Menu, press the Save softkey.
3 In the Save Menu, press the Format softkey and turn the Entry knob to
select Reference Waveform data (*.h5) .
4 Press the Source softkey and turn the Entry knob to select the source
waveform.
5 Press the softkey in the second position and use the Entry knob to
navigate to the save location. See "To navigate storage locations" on
page 272.
6 Finally, press the Press to Save softkey.
A message indicating whether the save was successful is displayed.
To save masks
Mask files can be saved to one of four internal (\Agilent Flash) locations
or to an external USB storage device.
1 Press [Save/Recall] > Save > Format; then, turn the Entry knob to select
Mask (*.msk).
To Next Page
Loading...
