Agilent Technologies Infinity 1260 - Page 171

Agilent 1260 Infinity RID User Manual 171
Index
EMF (early maintenance feedback) 21
time since last purge 21
environment 42, 42, 42
equilibration 87
error messages
fan failed 105
error messages
compensation sensor open 104
compensation sensor short 104
cover violation 106
heater fuse 108
heater resistance too high 107
ignition without cover 105, 105
lamp current too low 113
lamp current too high 112
lamp voltage too low 112
lamp voltage too high 112
leak sensor open 103
leak sensor short 103
leak 102
maximum temperature
exceeded 109
purge valve fuse blown 110
purge valve not connected 111
recycle valve fuse blown 110
recycle valve missing 111
remote timeout 101
shut-down 101
synchronization lost 102
thermal fuse open 107
timeout 100
undecipherable temperature
signal 109
wrong temperature profile 108
external contact
cable 157
F
fan failed 105
features
instrument layout 22
safety and maintenance 45
firmware
updates 138, 138
upgade/downgrade 138
upgrade/downgrade 138
flow cell pressure 84
flow cell
flushing 135
solvent information 167
flow cell 167
flow path 16
frequency range 43
frits and filters 84
front view of module 56
G
general error messages 100
GLP features 45
GLP 10
H
how the detector operates 11
how the detector operates
automatic purge 16
automatic recycling after analysis 16
automatic zero before analysis 16
flow path 16
recycle valve 16
how the detector operates
purge valve 16
humidity 43
I
installation
bench space 42
delivery checklist 48
environment 42, 42, 42
flow connections 59
of in, waste and recycle
capillaries 59
of the detector 56
site requirements 39
unpacking 48
interface board (BCD/LAN)
replacing 139
interfaces 25
internet 169
introduction
introduction to the detector 10
operation of the detector 11
L
LAN
cable 155
leak handling system
replacing 137
leak sensor open 103
leak sensor short 103
leak 102
leaks
correcting 136
light intensity control 10
line frequency 43
line voltage 43
lithium batteries 164
M
maintenance
definition of 130
replacing firmware 138, 138
measurements 14
message
cover violation 106
heater fuse 108
heater resistance too high 107
ignition without cover 105, 105
lamp current too high 112