Agilent Technologies Infinity 1260 - Page 172

172 Agilent 1260 Infinity RID User Manual
Index
lamp current too low 113
lamp voltage too high 112
lamp voltage too low 112
maximum temperature
exceeded 109
not enough light 115
purge time running 114, 114
purge valve fuse blown 110
purge valve not connected 111
recycle valve fuse blown 110
recycle valve missing 111
remote timeout 101
thermal fuse open 107
unbalanced diodes 115
undecipherable temperature
signal 109
wait for purge 114
wrong temperature profile 108
mobile phase recycling 85
more settings 70
N
noise 86
non-operating altitude 43
non-operating temperature 43
not-ready message 114
not-ready messages
not enough light 115
purge time running 114, 114
unbalanced diodes 115
wait for purge 114
O
operating Altitude 43
operating temperature 43
optical balance procedure 124
optical unit temperature 84
optical balance 123
optimization
check for leaks 84
consider solvent changes with
time 85
control the optical unit
temperature 84
do not overpressurize the flow
cell 84
eliminate mobile phase/column
combination problems 86
flush the degasser 85
position the solvent and waste
reservoirs correctly 84
recycle mobile phase 85
use an appropriate response
time 85
use the correct solvents 84
verify frit, filter and fitting quality 84
P
packaging
damaged 48
parts identification
accessory kit 49, 142
parts identification
cables 145
parts
damaged 48
missing 48
performance specifications 44
physical specifications 43
power supply indicator 92
power consideration 40
power consumption 43
power cords 41
R
radio interference 165
refractive index calibration
procedure 118
refractive index detector optimization 64
refractive index detector optimization 84
refractive index calibration 118
refractive index
calibration 118
optical balance 123
remote
cable 150
repairs
cautions and warnings 131
correction leaks 136
flow cell flushing 135
replacing interface board
(BCD/LAN) 139
replacing leak handling system 137
replacing firmware 138, 138
response time 85
restriction capillary 86
RS-232C
cable 156
communication settings 34
S
safety class I 161
safety information
lithium batteries 164
safety
general information 161
standards 43
symbols 160
serial number
information 24
settings 68
shut-down 101
site requirements 39
power cords 41
solvent and waste reservoirs 84
Solvent Information 64
solvent information 167
solvents 84, 85, 167
sound emission 166