72 PL-GPC 220 User Manual
7 Maintenance
Warnings and Cautions
Burns
Touching hot parts may cause burns.
➔ Allow any hot parts to cool.
Fire, electrical shock, burns and damage to the instrument
Moisture inside the instrument or on connectors is an electrical safety hazard.
Touching the connectors may bend the pins and therefore damage the instrument.
Hot parts are accessible in maintenance area.
➔ Switch instrument off, disconnect both power cords and allow any hot parts to cool
before undertaking any cleaning or maintenance procedures.
➔ Ensure that no moisture enters the instrument.
➔ Do not attempt to clean any connectors.
Personal injury or damage to the product
Agilent is not responsible for any damages caused, in whole or in part, by improper
use of the products, unauthorized alterations, adjustments or modifications to the
products, failure to comply with procedures in Agilent product user guides, or use of
the products in violation of applicable laws, rules or regulations.
➔ Use your Agilent products only in the manner described in the Agilent product user
guides.
Safety standards for external equipment
➔ If you connect external equipment to the instrument, make sure that you only use
accessory units tested and approved according to the safety standards appropriate
for the type of external equipment.
To Next Page
Loading...
Need help?
General
