Aim STANAG3910 User Manual

7. Technical DATA
ANET3910-EN Users Manual
53
Signal Waveform: Amplitude modulated sine wave
Output: Amplitude: ~ 4,5V
p-p
, High voltage level
Output Impedance: ~ 51 ohm
Coupling: AC coupled
Modulation Ratio: ~ 3 : 1
Carrier Frequency: 1kHz +/-50ppm
Connectors
Back panel:
15 pol. high density DSUB, female
- Trigger IN and OUT
- Discrete-I/O
- IRIG-IN and IRIG-OUT
USB Type-A connector
RJ45 Ethernet Connector (female)
DC Power Input (2,5mm centre pin)
Front panel:
STANAG3838 Connector:
- 15 pol. high density DSUB, female for STANAG3838 bus
STANAG3910 Connectors:
- 9 pol. DSUB, female for electrical STANAG3910 bus
Buttons
Power ON-OFF
Emergency Boot
Trigger In
TTL compatible Input Level, 1KΩ series resistor and fast ESD
protection. Rising Edge sensitive, required pulse width > 75 ns
Trigger Out
Output with TTL Level, series resistor of 82Ω and fast ESD
protection.
Output-Strobe pulse width: 500ns
Discrete IO
User definable Input/Output selection done by software,
Input High voltage 3.0V … 35.0V.
Input Low voltage max. 0.8V
Output High voltage minimum 4V (default), external voltage up to
35V max
Output Low voltage 0.4V max
Maximum Sink Current of each open collector 50 mA
Please note: When the default 5V for the discrete outputs are not
used, provide a serial resistor in line with the open collector
transistor. If using a discrete pin as input, make sure that the output
mode is set to default before connecting an external voltage.
Otherwise the transistor can be damaged.
Voltage Supply
Input Voltage Range
- VIN : 9VDC…15VDC (12VDC recommended)

Aim STANAG3910 Specifications

General

Brand	Aim
Model	STANAG3910
Category	Control Unit
Language	English