172
Settings and Adjustments
Station programming
4
System Information
Custom Sound Registry
Register a maximum of 100 audio files to be used for call acknowledged tones. (total length should not exceed
approximately 200 seconds).
Supported file format
• File Type: .wav
• File name: Within 41 characters (excluding extension)
For audio files used for message paging, messages when paging are searched by letter or number, so enter a letter
or number as the first character.
• Sample Size: 16 bits
• Sample Rate: 8 kHz and 16 kHz
8 kHz (when "Audio Codec" is set to "G.711 (μ-Law)" or "G.711 (A-Law)")
16 kHz (when "Audio Codec" is set to "G.722")
Contact the system administrator for information on the audio codec.
• Channel: 1 (mono)
How to register an audio file
1. Click [Browse] at the end of the row for the station in which the file is to be registered.
2. Select the audio file to register, and click [Open].
• Name: The name of the registered file is shown.
The name will be shown as the setting value when configuring the ringtone etc.
• Browse for .wav file: The audio file reference destination is shown.
3. Click [Update].
Note
• If using a file for a ringback tone, ringtone, or network camera event tone, add a period of silence in the .wav file if the tone is
to be intermittent.
• Sample files of custom tones are provided on our website (
https://www.aiphone.net/support/) for download. Use the files in it
as audio sources.
To Next Page
Loading...
Need help?
General
