126
Settings and Adjustments
Configuring on the station
4
Monitor Settings
Configure settings related to monitoring and scan monitoring.
Scan monitoring: This function automatically switches monitoring between multiple stations and network cameras
(other than VoIP phones) for a certain interval.
1. Tap [Monitor] on the Settings (1/2) screen.
• The Monitor Settings screen will be shown.
2. Configure the settings.
3. Tap [Back].
• The settings will be saved.
Entry Description Settings Default values
MONITOR TIMER Set the monitoring timer by station. Scan
Monitor must be end manually.
• 10 - 600 sec: Configure
between 10 and 600 sec
(by 1 sec).
• ∞ (infinite): No timeout.
60 sec
SCAN MONITOR
DWELL TIME
Set the dwell time to change destination for
scan monitor.
• 5 sec
• 10 sec
• 30 sec
5 sec
Scan Monitor Settings Configure the stations and network cameras
to perform scan monitoring.
Refer to
“How to configure Scan Monitoring
(→page 127)” for information on how to
configure this.
--
To Next Page
Loading...
