84
How to use
Checking the System
3
Performing Device Check
Check malfunctions for speaker, microphone, program, call button and option input of the stations that are registered
in this station's Address Book (except VoIP phones).
IX-MV, IX-DA, and IX-BA can be checked only for program malfunctions.
It is not possible to check for network camera malfunctions.
Malfunctions can also be automatically checked on a periodic basis (“Supervision Settings (administrator privileges
only) (→page 158)”).
Device Check results are also stored on the microSD card.
Performing manual Device Check
1. Tap [Status] on the Home screen.
2. Tap [Device Check].
3. Enter the administrator password,
and then tap [ENTER].
This password is the same as the administrator
password for Web configuration. Contact your
system administrator for details.
• A short beep will be heard from each station, in
order to check for speaker/microphone
malfunctions.
• Once malfunction monitoring begins, the
screen returns to the Status screen.
If an error was detected, [Status] on the Home
screen turns from green to red.
Important
• Stations that cannot communicate cannot be checked for malfunctions. Use this function together with Line Supervision.
To Next Page
Loading...
Need help?
General
