38
How to use
Placing / Answering a Call
3
Note
• When calling a VoIP Phone, this will be the shorter time of
the time set for "Call Timeout" or the call duration
configured on the IP-PBX.
• It may not be possible to place a call. It depends on the
configuration of the station.
• The ringback tone may not be played, depending on the
settings.
• If the call duration configured on this station (for calls with a
VoIP phone, the call duration configured on the VoIP
phone) elapses, the call will automatically end. A
notification tone will play approximately 10 seconds prior to
the call ending. The notification tone may not play,
depending on the settings.
• If a page with a higher priority is received from another
station while making an outgoing call or during
communication, the outgoing call or call will be interrupted
and the station will switch to the page.
• Tap during a call to turn off the microphone and
camera of the station. Tap to turn them back on.
• When receiving another call while talking, a notification
tone will be heard from the handset or built-in speaker. Tap
to choose the station to communicate with.
(→page 74)
• If the call destination includes a VoIP Phone configured to
automatically answer a call, the VoIP Phone will
automatically answer.
To Next Page
Loading...
Need help?
General
