40
How to use
Placing / Answering a Call
3
Note
• When calling a VoIP Phone, this will be the shorter time of
the time set for "Call Timeout" or the call duration
configured on the IP-PBX.
• It may not be possible to place a call. It depends on the
configuration of the station.
• The call is placed using the priority that was set during
programming.
• The ringback tone may not be played, depending on the
settings.
• If the call duration configured on this station (for calls with a
VoIP Phone, the call duration configured on the VoIP
Phone) elapses, the call will automatically end. A
notification tone will play approximately 10 seconds prior to
the call ending. The notification tone may not play,
depending on the settings.
• If a page with a higher priority is received from another
station while making an outgoing call or during a
communication, the outgoing call or call will be interrupted
and the station will switch to the page.
• Tap during a call to turn off the microphone and
camera of the station. Tap to turn them back on.
• When receiving another call while talking, a notification
tone will be heard from the handset or built-in speaker. Tap
to choose the station to communicate with.
(→page 74)
• If the call destination includes a VoIP Phone configured to
automatically answer a call, the VoIP Phone will
automatically answer.
To Next Page
Loading...
Need help?
General
