80
Programs
You can load up to 4 insert effects to each program. You can do this in Main Mode, XYFX Mode,
Program Edit Mode, and the Channel Mixer.
Note: In XYFX Mode, the effects act like a single insert effect on that program. In fact, XYFX is the name
of the insert effect that is loaded when use this mode.
To load a program insert effect in Main Mode:
1. Use the Track field to select the track that uses the program with the desired pad—the program it
uses will be selected automatically.
2. If the channel strip is not already shown, tap the small triangle (X) icon below the Project field to
show it.
3. Tap the second (four-squares) icon at the top of the channel strip. The channel strip will now show
settings for the current program.
4. Tap the pencil icon next to Inserts, and then use the window that appears to load or edit effects.
To load XYFX for a program in XYFX Mode:
1. Select the desired program in another mode, and then enter XYFX Mode.
2. If you have not yet used XYFX Mode for this program, tap Insert XYFX on the touchscreen to load it
and show the XY pad.
Note: If you already have 4 insert effects loaded, you will need to clear one of the insert effect slots
before doing this.
If you have already used XYFX Mode for this program, the XY pad will appear.
3. If the Setup panel is not shown, tap Setup in the lower-right corner to show it.
4. Use the Preset field to load an effect. Use the controls below the Preset field to edit the effect.
To Next Page
Loading...
Need help?
General
