AKYAPAK-AHS-UserManual-2019.03.11
Area of danger may change as per the size of the material that is being bent by the operator
besides the operation area of the machine. In brief, do not enter operation area of the
materials during the operation of the machine. This is very dangerous. Never attempt this.
Ensure that there is no unnecessary tools or equipment in the operation area before starting
to work with the machine as this may cause damage to the machine or the operator. Pay
attention to these recommendations.
WARNINGS ON OPERATION
Pay attention to the following points in order to prevent electric shocks and risky conditions.
Do not press the function buttons while the machine is being operated.
Follow the technical codes and local wiring regulations during the installation of electrical
equipment.
Do not place any other equipment that may cause noise beside the machine. If the noise
interferes with the signal waves, this may cause wrong movement and risks.
Prevent damage to the cable and do not apply pressure on the cable, otherwise electric
shock or risks may occur.
Do not touch any operating part when the machine is powered on. Do not enter the
operation area. These behaviours may cause injuries.
Ensure that no foreign tools, equipment or person (other than operator) is present in the
operation area during the operation of this machine. Then start the operation.
Following areas are dangerous during the operation of the machine.
Do not put your hand or body in the application area.
Death or serious injury such as breaking the arm or a leg may occur.
STORAGE
Machine shall be protected against external conditions (rain, extreme heat etc.) in its
operation area and shall be stored indoors. All metal equipment on the machine shall be
lubricated with protective grease if the machine will not be operated for a long time. Cover
the machine to protect it against factors such as dust.
Do not store or operate the machine in damp conditions with poisonous gas or liquid.
To Next Page
Loading...
