AKYAPAK-AHS-UserManual-2019.03.11
REGULAR LUBRICATION AND CHECKING OF OIL LEVEL
Information on this subject are given in detail.
REGULAR CLEANING
Dusts stick on the roll during bending operation. Rolls shall be cleaned and their surfaces
shall be checked after each bending operation. It may not be possible to bend very tough
materials even if the rolls are strengthened. Machines shall be kept away from dusty air
conditions.
INSPECTION OF WEARABLE PARTS
List of the parts used in the machine is given below. Operator shall inspect the parts
carefully, and inform the maintenance personnel if any irregularities, such as unusual noises
from the machine or irregular operation, are observed.
REPAIR
Machine shall be turned off and power shall be cut off when the error occurs. Machine shall
be repaired by qualified staff.
CAUTION!
Cut the power off and turn off the machine during any maintenance and repair operations.
LUBRICATION OF THE REDUCER
Reducer used in our machines is delivered with the oil. Oil in the reducer shall be replaced
annually and at every 2000 to 2500 hours of operation. Mixing of oils with various grades
and filling the reducer with this mixture is not recommended. Check the oil level in the
reducer at least every month.
To Next Page
Loading...
