AKYAPAK-AHS-UserManual-2019.03.11
It is strictly forbidden to perform any mechanical or maintenance operation without applying
the machine isolation procedure. During the removal and installation of any part, check
whether it fits its place and do not forget any foreign materials during the operation.
Do not get on the machine. Use genuine parts while replacing any part.
Electrical components shall conform with the values specified in wiring diagrams and shall
have equivalent safety properties. Contact AKYAPAK in case of doubt. Otherwise, AKYAPAK
accepts no responsibility.
Safety information are provided above. Please read the safety information carefully and
always bear in your mind to prevent physical damages and equipment damages.
Do not remove or replace any tool. This may cause fires, malfunctions or erratic operation.
Do not weld directly on the machine. This may cause malfunctions or erratic operation.
Do not change the parameters and internal settings of the machine, this may cause risks or
erratic operation.
PREVENTION OF ACCIDENTS
DANGER
Manufacturer has designed and manufactured this machine conforming with the relevant
standards with reference to DIN EN-292-1, DIN EN-292-2, DIN EN-60204-1 principles for
safety design harmonized standards and 98-37 EC safety directives, EC-Directives
2006/42/EC, EC-Low Voltage Directives 73/23/EWG EC-, Electromagnetic Directives
89/336/EC i.d.F. 93/31/EC covering international directives and methods.
Employer's duty here is to warn the staff against risks, to train against possible accidents,
and to provide required protective safety equipment and apparatus for the safety of the
operator.
Operator shall be used to his/her position before starting to work, and characteristic
features of the machine shall be controlled by the operator.
Machine shall only be used by staff who read the operation manual and understood its
contents.
Directives, recommendations and general safety rules included in this manual shall be
strictly followed by the user. Accident risk will be increased when one or more machine parts
To Next Page
Loading...
