AKYAPAK-AHS-UserManual-2019.03.11
MAINTENANCE AND INSPECTION
PROCEDURE FOR ISOLATION OF THE MACHINE
As always, turn off this machine's power system from the main switch for maintenance,
repair and similar operations. Disengage hydraulic circuit pumps.
Maintenance and repair operations shall be performed by the person taking the precautions
specified above. If this is a simple operation, this person can be the operator after taking the
precautions specified above.
Main switch and hydraulic system shall be turned off is the machine is not operated.
In case of an electric shock, you shall take the injured person away from the power leak first.
But, this is also a potential risk. That is, electric shock is transferred to the person touching
when the body of the injured person is touched. Therefore, you shall turn off the power
from the main switch, if possible, or move the body of the injured person with an insulating
material (wood or PVC etc.) Take the injured person to a medical facility immediately.
All operations including installation, operation, maintenance, repair etc. on power
installation shall be performed by authorized and qualified electric technicians.
Faults that may cause unsafe operation of the machine shall be corrected as soon as
possible.
SAFETY DURING MAINTENANCE
Always turn off the power and hydraulic systems before starting any maintenance or
replacement operation. Lock the required parts and put warning plates where required.
These precautions are always required in order to prevent accidents.
Perform maintenance, observation and inspection tasks periodically.
Inform the operator first before any maintenance operation.
Check whether the safety systems are active after any maintenance operation.
Replace the improper parts of the machine immediately. Always use the genuine spare parts
of the manufacturer.
AKYAPAK does not provide warranty against damages in the machine caused by parts
provided by other parties.
Regular maintenance of the mechanic and electrical parts is very important as it would
increase the life cycle of the machine and improve the performance.
To Next Page
Loading...
