AKYAPAK-AHS-UserManual-2019.03.11
ROUTINE INSPECTIONS AND MAINTENANCE
• Always bring the main switch to 0 position and apply the machine isolation
procedure before any maintenance or cleaning operation.
• All repair and maintenance operations shall be started when the machine is stopped
and electrical connection is cut off.
• Always check if the emergency stop button operates.
• Ensure that plate surfaces to be bent are clean and dry. Clean and dry the frame and
surfaces used.
• If the machine is not being operated for maintenance or service reasons, put a
warning sign indicating this to a suitable position on the machine.
• Clean the surfaces of rolls. Operation area shall be clean and dry. Clean the chippings
and dust collected around the machine at the end of each work day. Use mildly damp
cloth or pressurized dry air for cleaning. Do not clean the surface of the machine with
flammable, caustic or abrasive cleaning materials.
• Do not use pressurized air to clean inside the panel.
• Check the oil level in hydraulic system. If the oil level is low, add oil. Deactivate the
power connection before starting any of these operations.
END OF WORKDAY MAINTENANCE
• Deactivate electric and hydraulic power connections.
• Remove chippings, burrs and foreign materials on all surfaces of the machine. Use a
goggle to protect your eyes against harmful substances.
• If the machine will not be used for a long period of time, bring the main switch to off
position. Turn off hydraulic system completely.
• Clean the rolls them dry if required.
• Use protective oil to protect rolls against corrosion.
To Next Page
Loading...
