AKYAPAK-AHS-UserManual-2019.03.11
BENDING SPEED
Our standard machines have 2 bending speeds. These speeds vary gradually.
1. Normal speed
2. Low speed
Low speed pulls the material during pre-bending in its axis. Low and normal speed buttons
are placed on the control panel.
Rabbit symbol is used for normal speed, and tortoise symbol is used for low speed.
Optionally, you may change the bending speed without increasing it gradually. In this option,
bending option may be set as per the experience of the user and thickness of material from
0 to maximum speed.
Pumps used in this system are special and do not allow an increase in the oil temperature,
but controls the oil flow according to bending speed.
BUTTONS
There are several buttons used to protect the operator and the machine.
USAGE AND FUNCTIONS OF THE BUTTONS
After bending operation, lower roll is slowed until it touches its switch. If the lower roll does
not slow, cover shall not open.
Cover shall open when the user presses the cover opening button in order to remove the
material. Then the upper roll is raised and material can be removed easily. Also, system does
not operate and rolls do not rotate in this position.
After removing the material, upper roll starts to move when you press the cover closing
button, and this is continued until the cover touches the switch. Machine is ready for
another casting operation. If you cannot manage the machine by the buttons:
To Next Page
Loading...
