AKYAPAK AHS - Page 59

A: Akçalar Sanayi Bölgesi Sanayi Cad.
No: 8/A 16225 Akçalar BURSA / TURKEY
T: +90 224 280 75 00
F: +90 224 280 75 01
E: info@akyapak.com.tr
W: akyapak.com.tr
Page: 59/94
AKYAPAK-AHS-UserManual-2019.03.11
• If you try to compress the cone plate by lifting the cone when lower shaft is in the
lowest position,
• Machine does not bend conically (you may damage the shaft, cone thrust of the
machine or the material you want to bend conically.)
If the surface that contact the cone thrust roll of the material is rolled up or down, if it is
crushed or deformed, operations described above shall be performed.
NOTE = Ensure that you have only compressed to provide rotation of the plate at a distance
of 5 to 10 cm from the bigger diameter side of the conical plate.
Material is removed from the machine as follows at the end of the bending operation.
• Lowers the level of lower ROLL.
• Press button no. 2, upper cover shall be opened, and then upper ROLL shall move
upwards.
“
1. Bent plate is removed from the upper ROLL.
2. Upper ROLL moves upwards and cover is closed by pressing button no. 1.
Each move is checked from the limit switch to ensure that these operations are performed
smoothly and safely.