7210 SAS M, T, X, R6 Basic System Configuration Guide Page 11
Preface
About This Guide
This guide describes system concepts and provides configuration explanations and examples
to configure 7210 SAS-M, T, X and R6 boot option file (BOF), file system and system
management functions.
On 7210 SAS devices, not all the CLI commands are supported on all the platforms and in all
the modes. In many cases, the CLI commands are mentioned explicitly in this document. In
other cases, it is implied and easy to know the CLIs that are not supported on a particular
platform.
All the variants of 7210 SAS-M and 7210 SAS-T can be configured in two modes, that is in
network mode and in access-uplink mode. In network mode configuration 7210 SAS-M and
7210 SAS-T uses IP/MPLS to provide service transport. In access-uplink mode configuration
7210 SAS-M and 7210 SAS-T uses Ethernet QinQ technology to provide service transport.
The mode can be selected by configuring the BOF appropriately.
This guide also presents examples to configure and implement various tests.
Notes:
• This user guide is applicable to all 7210 SAS-M, 7210 SAS-T, 7210 SAS-R6 and
7210 SAS-X platforms, unless specified otherwise.
• In either mode, it is expected that the user will only configure the required CLI
parameters appropriate for the mode he intends to use. Unless otherwise noted, most
of the configuration is similar in both the network mode and Access uplink mode.
• Only 7210 SAS-M and 7210 SAS-T supports access-uplink mode. 7210 SAS-X and
7210 SAS-R6 does not support access-uplink mode. 7210 SAS-X and 7210 SAS-R6
supports only MPLS uplinks and implicitly operates in network mode.
• On 7210 SAS devices, not all the CLI commands are supported on all the platforms
and in all the modes. In many cases, the CLI commands are mentioned explicitly in
this document. In other cases, it is implied and easy to know the CLIs that are not
supported on a particular platform.
To Next Page
Loading...
Need help?
General
