Alcatel-Lucent 7210 SAS M - Sas-T

System Management
7210 SAS M, T, X, R6 Basic System Configuration Guide Page 435
With the no form of the command, the software does not allocate any resources for use by ingress
SAP QoS policies using IPv6 criteria. If no resources are allocated for use, then software fails all
attempts to associate a service entity (For example: SAP, IP interface, etc.) with a ingress filter policy
using this match criteria.
Parameters num-resources — Specifies the maximum amount of resources for use by this SAP ingress Qos policy
match criteria.max — It is a special keyword. If user specifies max, then the software allocates one
chunk when the first SAP is associated with a SAP ingress QoS policy using this match criteria.
It continues to allocate resources to SAPs associated with SAP ingress QoS policy using this
criteria, as long as the total amount of resources allocated does not exceed the resources allocated
to SAP ingress QoS policies (configured with the command config> system> resource-profile>
ingress-internal-tcam> qos-sap-ingress-resource command) and chunks are available for use.
Values :
qos-sap-ingress-resource
Syntax qos-sap-ingress-resource
no qos-sap-ingress-resource
Context configure>system>resource-profile
Description This command allows the user to allocate maximum resources for use by SAP ingress QoS policies
using any of the supported match criteria. This command limits the total amount of chunks allocated
for use by SAP ingress QoS policies to the value specified by num-resources. In other words, the
cumulative sum of chunks allocated to different match criteria supported by SAP ingress QoS policies
cannot exceed the value configured with num-resources.
Platforms Min value
(per node)
Max value
(per node)
Default
Values
7210 SAS-M
(per node)
0 10 max
7210 SAS-X
(per node)
0 8 max
7210 SAS-T
Access-Uplink
mode (per node)
0 7 max
7210 SAS-T
Network Mode
(per node)
0 6 max
7210 SAS-R6
(per IMM)
0 5 max