Alcatel-Lucent 7210 SAS M - Saving a Configuration to a Different Filename; Rebooting

Boot Option Files
7210 SAS M, T, X, R6 Basic System Configuration Guide Page 161
Saving a Configuration to a Different Filename
Save the current configuration with a unique filename to have additional backup copies and to edit
parameters with a text editor. You can save your current configuration to an ASCII file.
Use either of the following CLI syntax to save a configuration to a different location:
CLI Syntax: bof# save [cflash-id]
Example : A:ALA-1# bof
A:ALA-1>bof# save cf1:
A:ALA-1>bof#
or
CLI Syntax: admin# save [file-url] [detail] [index]
Example : A:ALA-1>admin# save cf1:\testABC.cfg
Saving config.# Saved to cf1:\testABC.cfg
... complete
A:ALA-1#
Rebooting
When an admin>reboot command is issued, the system reboots. Changes are lost unless the
configuration is saved. Use the admin>save file-url command to save the current configuration.
The user is prompted to confirm the reboot operation.If the now option is not specified, the user is
prompted to confirm the reboot operation.The reboot upgrade command forces an upgrade of the
device firmware (CPLD and ROM) and reboots.
NOTE: The auto-init option is available only on 7210 SAS-M/X/T. It is not supported on 7210
SAS-R6.
Use the following CLI syntax to reboot:
CLI Syntax: admin# reboot [upgrade][auto-init][now]
Example : A:ALA-1>admin# reboot
A:DutA>admin# reboot
Are you sure you want to reboot (y/n)? y