Alcatel-Lucent 7210 SAS M Configuration Guide

Boot Option Files
7210 SAS M, T, X, R6 Basic System Configuration Guide Page 143
Basic BOF Configuration
The parameters which specify location of the image filename that the router will try to boot from
and the configuration file are in the BOF.
The most basic BOF configuration should have the following:
• Uplink port or Ethernet Management port parameters
• Primary image location
• Primary configuration location
Following is a sample of a basic BOF configuration.
A:7210>show# bof
===============================================================================
BOF (Memory)
===============================================================================
primary-image ftp://*:*@135.254.170.29//import/panos_builds/nightly/2.0
/S80/MTU-sultan/
primary-config tftp://10.135.25.100/MTU/mtu3DGP.cfg
#eth-mgmt Port Settings:
eth-mgmt-disabled
#uplinkA Port Settings:
uplinkA-port 1/1/24
uplinkA-address 0
uplinkA-vlan 0
#uplinkB Port Settings:
uplinkB-port 1/1/2
uplinkB-address 0
uplinkB-vlan 0
#System Settings:
wait 3
persist off
console-speed 115200
no console-disabled
===============================================================================
A:7210>show#
Following is a sample of a basic BOF configuration for 7210 SAS-R6:
A:dut-a>show# bof
===============================================================================
BOF (Memory)
===============================================================================
primary-image ftp://*:*@192.168.87.201/./images/i386-cpm.tim
primary-config ftp://*:*@192.168.87.201/./images/dut-a.cfg
address 192.168.87.12/24 active
address 192.168.87.13/24 standby
static-route 135.250.124.0/24 next-hop 192.168.87.201
autonegotiate
duplex full
speed 100
wait 3
persist off

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English