Alcatel-Lucent 7210 SAS M - Configuring BOF Parameters

Boot Option Files
7210 SAS M, T, X, R6 Basic System Configuration Guide Page 155
Configuring BOF Parameters
The following output displays a BOF configuration7210 SAS-M/X/T:
A:7210>show# bof
===============================================================================
BOF (Memory)
===============================================================================
primary-image ftp://*:*@135.254.170.29//import/panos_builds/nightly/2.0
/S80/MTU-sultan/
primary-config tftp://10.135.25.100/MTU/mtu3DGP.cfg
#eth-mgmt Port Settings:
eth-mgmt-disabled
#uplinkA Port Settings:
uplinkA-port 1/1/24
uplinkA-address 0
uplinkA-vlan 0
#uplinkB Port Settings:
uplinkB-port 1/1/2
uplinkB-address 0
uplinkB-vlan 0
#System Settings:
wait 3
persist off
console-speed 115200
no console-disabled
===============================================================================
A:7210>show#
The following output displays a BOF configuration for 7210 SAS-R6:
A:dut-a>show# bof
===============================================================================
BOF (Memory)
===============================================================================
primary-image ftp://*:*@192.168.87.201/./images/i386-cpm.tim
primary-config ftp://*:*@192.168.87.201/./images/dut-a.cfg
address 192.168.87.12/24 active
address 192.168.87.13/24 standby
static-route 135.250.124.0/24 next-hop 192.168.87.201
autonegotiate
duplex full
speed 100
wait 3
persist off
console-speed 115200
no console-disabled
===============================================================================
A:dut-a>show#