Alcatel-Lucent 7210 SAS M - Configuring 1830 VWM

Configuring 1830 VWM
Page 302 7210 SAS M, T, X, R6 Basic System Configuration Guide
Configuring 1830 VWM
The following output displays creation of vwm-shelf:
NOTE: The card 1 correspond to slot #1 and card 2 corresponds to slot #2 on the 1830 CWDM
device. The optical modules or line cards are inserted into these slots.
*A:NS1333C2676# configure system vwm-shelf 3 create
*A:NS1333C2676>configure>system>vwm-shelf$ info
----------------------------------------------
no shutdown
----------------------------------------------
*A:NS1333C2676>configure>system>vwm-shelf$ info detail
----------------------------------------------
card 1
shutdown
no card-type
exit
card 2
shutdown
no card-type
exit
no shutdown
*A:NS1333C2676# show system vwm-shelf 3
===========================================================================
Shelf Summary
===========================================================================
Shelf-ID USB/ Admin Oper Number of
OMC State State Equipped slots
---------------------------------------------------------------------------
3 OMC UP UP 2
===========================================================================
Slot Summary
Slot-ID Provisioned Equipped Admin Oper
Type Type State State
---------------------------------------------------------------------------
1 Not Provisioned SFC8 DOWN DOWN
2 Not Provisioned SFC1D DOWN DOWN
===========================================================================
*A:NS1333C2676# configure system vwm-shelf 3 card 1 card-type SFC8
*A:NS1333C2676# configure system vwm-shelf 3 card 2 card-type SFC1D
*A:NS1333C2676# show system vwm-shelf
===========================================================================
Shelf Summary
===========================================================================
Shelf-ID USB/ Admin Oper Number of
OMC State State Equipped slots
---------------------------------------------------------------------------