Alcatel-Lucent 7210 SAS M Configuration Guide

Common Configuration Tasks
Page 152 7210 SAS M, T, X, R6 Basic System Configuration Guide
Accessing the CLI
To access the CLI to configure the software for the first time, follow these steps:
• When the power to the chassis is turned on, the 7210 SAS software automatically begins
the boot sequence.
• When the boot loader and BOF image and configuration files are successfully located,
establish a router connection (console session).
Console Connection
To establish a console connection, you will need the following:
• An ASCII terminal or a PC running terminal emulation software set to the parameters
shown in the table below.
• A standard serial cable connector for connecting to a RS232 port (provides a RJ45
connector).
Table 14: Console Configuration Parameter Values
Parameter Value
Baud Rate 115,200
Data Bits 8
Parity None
Stop Bits 1
Flow Control None

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English