System Commands
Page 464 7210 SAS M, T, X, R6 Basic System Configuration Guide
Delete
Last Rollback Delete Result: None
===============================================================================
Rollback Files
===============================================================================
Idx Suffix Creation Time Release User
Comment
-------------------------------------------------------------------------------
No Matching Entries
===============================================================================
A:7210SAS>show>system#
resource-profile
Syntax resource-profile [[active|configured]]
resource-profile [[active|configured]] policy-id [detail] (applicable only to 7210 SAS-
R6)
Context show>system
Description This command displays the resource-profile protocol configuration and state.
Parameters active|configure — keyword - Displays active or configured values.
Active values are those in use by the system currently. Configured values are those that have
been changed by the user and has not taken effect. For the system resource-profile parameters
that need a reboot to take effect, the active and configured values can be different. It typically
requires a node reboot or a card reset for it to take effect.
policy-id — Specifies a resource profile policy.
Output Show resource-profile Output — The following table describes resource-profile output fields.
Table 33: Show system resource-profile output fields.
Label Description
Ingress Queue
Mode
Enable – Enables SAP ingress queuing
Disable – Disable SAP ingress queuing
Ingress Internal
CAM
Displays the applications sharing ingress CAM resource.
Sap Ingress ACL
resource
Displays the resources configured for use by SAP Ingress ACL
policies.
IPv4 Resource
Displays the resources configured for use by ingress ACL poli-
cies that use ipv4-criteria.
Disable – No resources are allocated for use by this feature.
Therefore, no policies of this type can be associated to a SAP.