System Resource-Profile Commands
Page 434 7210 SAS M, T, X, R6 Basic System Configuration
Guide
Values [1-3]
Default 1
up-mep
Syntax [no] up-mep
Context configure>system>resource-profile>ingress-internal-tcam>eth-cfm
Description Note: This command is supported on 7210 SAS-M, 7210 SAS-T, 7210 SAS-X and 7210 SAS-R6
devices.
This command provides the context to allocate resources for CFM UP MEPs.
Resources for UP MEPs created on SAP and SDP Bindings are allocated from this pool.
NOTE: On 7210 SAS-R6, when a UP MEP on a SDP Binding is created resources are allocated for
the UP MEP on all the IMMs and when a UP MEP on a SAP is created resources are allocated only
on the IMM where the SAP is configured or on the set of IMMS if the SAP is configured over a LAG
With the no form of the command, the software does not allocate any resources for use by CFM UP
MEPs. If no resources are allocated for use, then software fails all attempts to configure an UP MEP.
Parameters num-resources — Specifies the maximum amount of resources for use by up-mep.
Values [0..2] (For 7210 SAS-X and R6)
[0..1] (For 7210 SAS-M and T)
ipv6-ipv4-match-enable
Syntax ipv6-ipv4-match-enable
no ipv6-ipv4-match-enable
Context configure>system>resource-profile>ingress-internal-tcam>qos-sap-ingress-resource
Description User needs to allocate resources from the SAP ingress QoS resource pool for ipv6-criteria by using
the command "configure> system> resource-profile> ingress-internal-tcam> qos-sap-ingress-
resource> ipv6-ipv4-match-enable" before using IPv6 criteria SAP ingress QoS policies.
These resources can be shared with SAP ingress policies that use IPv4 criteria. For more details about
the resource allocation for ingress filter policy and fields available for use with ingress filter policy
please refer the 7210 SAS-M,X,T, and R6 Router Configuration user guide. For more details about
the resource allocation for SAP ingress QoS policy please refer to 7210 SAS-M and 7210 SAS-X
QoS user guide.
To Next Page
Loading...
Need help?
General
