IP Router Command Reference
102 7705 SAR OS Router Configuration Guide
dns-server
Syntax dns-server ip-address [ip-address...(up to 4 max)]
Context config>router>dhcp>local-dhcp-server>pool>options
config>service>vprn>dhcp>local-dhcp-server>pool>options
Description This command configures the IP address of the DNS servers.
Parameters ip-address — the IP address of the DNS server in dotted-decimal notation. Up to four IP addresses
can be entered.
Values ipv4-address: a.b.c.d (host bits must be 0)
domain-name
Syntax domain-name domain-name
no domain-name
Context config>router>dhcp>local-dhcp-server>pool>options
config>service>vprn>dhcp>local-dhcp-server>pool>options
Description This command configures the default domain for a DHCP client that the router uses to complete
unqualified host names (without a dotted-decimal domain name).
The no form of the command removes the name from the configuration.
Parameters domain-name — the domain name for the client as an ASCII string
Values maximum 127 characters
lease-rebind-time
Syntax lease-rebind-time [days days] [hrs hours] [min minutes] [sec seconds]
no lease-rebind-time
Context config>router>dhcp>local-dhcp-server>pool>options
config>service>vprn>dhcp>local-dhcp-server>pool>options
Description This command configures the time from the assignment of the IP address until the client transitions to
a rebinding state.
The no form of the command removes the time from the configuration.
Default n/a
Parameters days — the lease rebinding time in days
Values 0 to 3650
To Next Page
Loading...
