Alcatel-Lucent 7705 - IP Filter Entry for PBR to a System IP or Loopback Address; Table 45 PBR CSM Extraction Queue Parameters

Common Configuration Tasks
298 7705 SAR OS Router Configuration Guide
Example: config>filter>ipv6-filter>entry# match
config>filter>ipv6-filter>entry>match# src-ip
11::12/128
config>filter>ipv6-filter>entry>match# dst-ip
13::14/128
config>filter>ipv6-filter>entry>match# exit
The following example displays a matching configuration.
A:ALU-7>config>filter>ipv6-filter# info
----------------------------------------------
description "ipv6-filter-main"
scope exclusive
entry 10 create
description "no-91"
match
dst-ip 13::14/128
src-ip 11::12128
exit
action forward exit
IP Filter Entry for PBR to a System IP or Loopback Address
A PBR rule can be set up to extract packets from the data path and send them to the CSM for
debugging or slow path forwarding, by having the next-hop point to a system IP or
loopback interface of the 7705 SAR.
The extracted traffic can be rerouted to a final destination based on a RIB lookup on the CSM.
The traffic is reinjected to the datapath based on the next-hop address.
Table 45 summarizes the queuing parameters for this functionality. These parameters are for
slow path queues created for PBR and are not user-configurable.
Table 45: PBR CSM Extraction Queue Parameters
Parameter Maximum Value
PIR 1500 kb/s
CIR 100 kb/s
MBS 20 (non-buffer-chained adapter cards)
80 (buffer-chained adapter cards)
CBS 8 buffers