Alcatel-Lucent 7705 - Table 32 Show Ipv6 Neighbor Output Fields

IP Router Command Reference
188 7705 SAR OS Router Configuration Guide
route-table
Syntax route-table [family] [ip-prefix[/prefix-length] [longer | exact]] | [protocol protocol-name] |
[summary]
Context show>router
Description This command displays the active routes in the routing table.
If no command line arguments are specified, all routes are displayed, sorted by prefix.
The following adapter cards support the full IPv6 subnet range for IPv6 static routes:
• 6-port Ethernet 10Gbps Adapter card
• 8-port Gigabit Ethernet Adapter card, version 2 and version 3
• 2-port 10GigE (Ethernet) Adapter card (on the v-port)
• 10-port 1GigE/1-port 10GigE X-Adapter card
For these cards, the supported route range for statically provisioned or dynamically learned routes is
from /1 to /128.
For all other cards, modules, and ports (including the v-port on the 2-port 10GigE (Ethernet) module),
the supported range for statically provisioned or dynamically learned routes is from /1 to /64 or is /128
(indicating a host route).
Parameters family — specifies the type of routing information to be distributed by this peer group
Values ipv4 — displays the routes that have the IPv4 family enabled,
excluding IP-VPN routes
ipv6 — displays the routes that are IPv6-capable, including IPv6
static routes
Table 32: Show IPv6 Neighbor Output Fields
Label Description
IPv6 Address The IPv6 address
Interface The name of the IPv6 interface
MAC Address The link-layer address
State The current administrative state
Expiry The amount of time before the entry expires
Type The type of IPv6 interface
RTR Specifies whether the neighbor is a router