Filter Command Reference
338 7705 SAR OS Router Configuration Guide
Filter Policy Commands
ip-filter
Syntax ip-filter filter-id [create]
no ip-filter filter-id
Context config>filter
Description This command creates a configuration context for an IPv4 filter policy.
IP filter policies specify either a forward or a drop action for packets based on the specified match
criteria.
The IP filter policy, sometimes referred to as an access control list (ACL), is a template that can be
applied to multiple network ports as long as the scope of the policy is template.
Any changes made to the existing policy, using any of the subcommands, will be applied immediately
to all network interfaces where this policy is applied.
The no form of the command deletes the IP filter policy. A filter policy cannot be deleted until it is
removed from all network interfaces where it is applied.
Parameters filter-id — the IP filter policy ID number
Values 1 to 65535
create — keyword required when first creating the configuration context. When the context is
created, you can navigate into the context without the create keyword.
ipv6-filter
Syntax ipv6-filter ipv6-filter-id [create]
no ipv6-filter ipv6-filter-id
Context config>filter
Description This command creates a configuration context for an IPv6 filter policy.
IP filter policies specify either a forward or a drop action for packets based on the specified match
criteria.
The IP filter policy, sometimes referred to as an access control list (ACL), is a template that can be
applied to multiple network ports as long as the scope of the policy is template.
Any changes made to the existing policy, using any of the subcommands, will be applied immediately
to all network interfaces where this policy is applied.
To Next Page
Loading...
