VRRP Command Reference
268 7705 SAR OS Router Configuration Guide
VRRP Monitor Commands
instance
Syntax instance interface interface-name vrid virtual-router-id [ipv6] [interval seconds] [repeat
repeat] [absolute | rate]
Context monitor>router>vrrp
Description This command enables monitoring for VRRP instances.
Parameters interface-name — specifies the name of the existing IES/VPRN interface on which VRRP is
configured
virtual-router-id — specifies the virtual router ID for the existing IES/VPRN interface, expressed
as a decimal integer
Values 1 to 255
ipv6 — specifies monitoring the IPv6 instance
seconds — specifies the interval for each display in seconds
Values 3 to 60
Default 5
repeat — specifies the number of times the command is repeated
Values 1 to 999
Default 10
absolute — specifies that raw statistics are displayed, without processing. No calculations are
performed on the delta or rate statistics.
rate — specifies the rate-per-second for each statistic instead of the delta
Output The following output is an example of a router VRRP instance summary information.
Sample Output
monitor router vrrp instance interface n2 vrid 1
*A:7705:DutA# monitor router vrrp instance interface vrrpMasNode vr-id 10 absolute
===============================================================================
Monitor statistics for VRRP Instance 10 on interface "vrrpMasNode"
===============================================================================
-------------------------------------------------------------------------------
At time t = 0 sec (Base Statistics)
-------------------------------------------------------------------------------
Become Master : 0 Master Changes : 0
Adv Sent : 2 Adv Received : 0
Pri Zero Pkts Sent : 0 Pri Zero Pkts Rcvd: 0
To Next Page
Loading...
