Filter Policies
7705 SAR OS Router Configuration Guide 407
Monitor Commands
filter
Syntax filter ip ip-filter-id entry entry-id [interval seconds] [repeat repeat] [absolute | rate]
Context monitor
Description This command monitors the counters associated with the IPv4 filter policy.
Parameters ip-filter-id — the IPv4 filter policy ID
Values 1 to 65535
entry-id — only the counters associated with the specified filter policy entry will be monitored
Values 1 to 64
seconds — configures the interval for each display in seconds
Values 3 to 60
Default 5
repeat — configures how many times the command is repeated
Values 1 to 999
Default 10
absolute — the raw statistics are displayed without processing. No calculations are performed on
the delta or rate statistics.
rate — the rate per second for each statistic is displayed instead of the delta
filter
Syntax filter ipv6 ipv6-filter-id entry entry-id [interval seconds] [repeat repeat] [absolute | rate]
Context monitor
Description This command monitors the counters associated with the IPv6 filter policy.
Parameters ipv6-filter-id — the IPv6 filter policy ID
Values 1 to 65535
entry-id — only the counters associated with the specified filter policy entry will be monitored
Values 1 to 64
To Next Page
Loading...
