Alcatel-Lucent 7705 - Debug Commands

IP Router Command Reference
88 7705 SAR OS Router Configuration Guide
Debug Commands
debug
—trace
— destination trace-destination
— [no] enable
— [no] trace-point [module module-name] [type event-type] [class event-class] [task task-name]
[function function-name]
— router router-instance
— [no] bgp
— [no] ip
— [no] arp
— dhcp [interface ip-int-name]
— detail-level {low | medium | high}
—no detail-level
— mode {dropped-only | ingr-and-dropped | egr-ingr-and-dropped}
—no mode
— [no] icmp
—
icmp6 [ip-int-name]
—no icmp6
— [no] interface [ip-int-name | ip-address]
— [no] neighbor
— packet [ip-int-name | ip-address] [headers] [protocol-id]
—no packet [ip-int-name | ip-address]
— route-table [ip-prefix/prefix-length] [longer]
—no route-table
— [no] isis
— [no] ldp
— [no] local-dhcp-server server-name [lease-address ip-address]
— [no] local-dhcp-server server-name
[mac ieee-address]
— detail-level {low | medium | high}
—no detail-level
— mode {dropped-only | ingr-and-dropped | egr-ingr-and-dropped}
—no mode
— [no] mpls
— [no] ospf
— [no] rsvp
Note:
• For information on MPLS, LDP, and RSVP, refer to the 7705 SAR OS MPLS Guide.
• For information on OSPF, IS-IS, and BGP, refer to the 7705 SAR OS Routing Protocols
Guide.
• For information on configuring ETH-CFM on network interfaces, refer to the
7705 SAR OS OAM and Diagnostics Guide.
• For information on self-generated traffic re-marking (sgt-qos), refer to the
7705 SAR OS Quality of Service Guide.
• For information on policy options, see Route Policies.