Alcatel-Lucent 7705 - Nat Pool

Filter Command Reference
400 7705 SAR OS Router Configuration Guide
nat pool
Syntax nat pool [pool-id |pool-name] [detail]
Context show>security>zone
Description This command displays NAT pool information.
Parameters pool-id — displays detailed information for the specified zone pool ID
Values 1 to 100
pool-name — displays information for the specified zone pool name
Values 1 to 32 characters (must start with a letter)
detail — displays detailed information on the specified pool ID
Output The following output is an example of zone pool information:
Sample Output
*A-ALU-1# show security zone 1 nat pool 1 detail
===============================================================================
Security Zone
===============================================================================
Zone Id : 1 State : Committed
Name : Service Inbound Zone
===============================================================================
===============================================================================
NAT Pool
===============================================================================
Pool Id : 1 Direction : Inbound
Type : source-nat
Name : (Not Specified)
Description : Pool 1:
-------------------------------------------------------------------------------
Entry Id : 1 Direction : Inbound
IP Address : ies-10010.30.10.1 Port : Any
-------------------------------------------------------------------------------
Num of Entries : 1
===============================================================================
*A-ALU-1#
policy
Syntax policy [entry entry-id] [detail] [statistics]
Context show>security>zone
Description This command displays NAT policy information.