Alcatel-Lucent 7705 - Filter Management Tasks; Renumbering Filter Policy Entries

Filter Management Tasks
314 7705 SAR OS Router Configuration Guide
Filter Management Tasks
This section discusses the following filter policy management tasks:
• Renumbering Filter Policy Entries
• Modifying an IP Filter Policy
• Modifying a MAC Filter Policy
• Modifying a VLAN Filter Policy
• Removing and Deleting a Filter Policy
Renumbering Filter Policy Entries
The 7705 SAR OS exits the matching process when the first match is found and then executes
the actions in accordance with the specified action. Because the ordering of entries is
important, the numbering sequence can be rearranged. Entries should be numbered from the
most explicit to the least explicit.
Use the following CLI syntax to resequence existing IP, MAC, and VLAN filter entries:
CLI Syntax: config>filter
ip-filter filter-id
renum old-entry-id new-entry-id
Example: config>filter>ip-filter# renum 10 15
config>filter>ip-filter# renum 30 40
config>filter>ip-filter# renum 40 1
CLI Syntax: config>filter
ipv6-filter ipv6-filter-id
renum old-entry-id new-entry-id
Example: config>filter>ipv6-filter# renum 10 15
config>filter>ipv6-filter# renum 30 40
config>filter>ipv6-filter# renum 40 1
CLI Syntax: config>filter
mac-filter filter-id
renum old-entry-id new-entry-id
Example: config>filter>mac-filter# renum 10 15
config>filter>mac-filter# renum 30 40
config>filter>mac-filter# renum 40 1