Alcatel-Lucent 7705 - Applying VLAN Filter Policies to a Ring Port

Filter Policies
7705 SAR OS Router Configuration Guide 313
CLI Syntax: config>router# interface ip-int-name
egress
filter ipv6 ipv6-filter-id
ingress
filter ipv6 ipv6-filter-id
Example: config>router# interface to-104
config>router>if# ingress
config>router>if>ingress# filter ip 10
config>router>if# exit
A:ALU-48>config>router# info
#------------------------------------------
# IP Configuration
#------------------------------------------
...
interface "to-104"
address 10.0.0.10/32
port 1/1/1
ingress
filter ip 10
exit
exit
...
#------------------------------------------
A:ALU-48>config>router#
Applying VLAN Filter Policies to a Ring Port
VLAN filter policies can be applied to a ring port on the 2-port 10GigE (Ethernet) Adapter
card and 2-port 10GigE (Ethernet) module. The filter operates on ingress traffic. Filter
policies must be created before they can be applied. Create filter policies in the
config>filter context.
CLI Syntax: config>port>ethernet# vlan-filter filter-id
Example: config>port>ethernet# vlan-filter 2
A:ALU-48>config>port>ethernet# info
#------------------------------------------
...
vlan-filter 2
...
#------------------------------------------
A:ALU-48>config>port>ethernet#