Filter Management Tasks
322 7705 SAR OS Router Configuration Guide
Removing a Filter from a Ring Port
To remove a VLAN filter from a ring port, enter the following CLI command. Including
filter-id is optional because only one filter can be applied to a port.
CLI Syntax: config>port>ethernet# no vlan-filter [filter-id]
Example: config>port>ethernet# no vlan-filter 2
Deleting a Filter
After you have removed the filter from all the network interfaces, SAPs, and SDPs (spoke
and/or mesh) where it was applied, use the following CLI syntax to delete the filter:
CLI Syntax: config>filter# no ip-filter filter-id
CLI Syntax: config>filter# no ipv6-filter ipv6-filter-id
CLI Syntax: config>filter# no mac-filter filter-id
CLI Syntax: config>filter# no vlan-filter filter-id
Example: config>filter# no ip-filter 2
config>filter# no mac-filter 55
To Next Page
Loading...
