Alcatel-Lucent 7705 - Notes

IP Router Configuration
7705 SAR OS Router Configuration Guide 65
Configuring IPv6 Parameters
IP version 6 (IPv6) addresses are supported on:
• access ports (IES only); for a complete list of cards and ports that support IES IPv6
SAPs, refer to the 7705 SAR OS Services Guide, “IES for Customer Traffic”
• network ports (null or dot1q encapsulation) on:
→ 2-port 10GigE (Ethernet) Adapter card (v-port only)
→ 8-port Ethernet Adapter card, version 2
→ 6-port Ethernet 10Gbps Adapter card
→ 8-port Gigabit Ethernet Adapter card
→ 10-port 1GigE/1-port 10GigE X-Adapter card
→ Packet Microwave Adapter card
→ Ethernet ports on the 7705 SAR-F
→ Ethernet ports on the 7705 SAR-M (all variants)
→ Ethernet ports on the 7705 SAR-A (all variants)
→ Ethernet ports on the 7705 SAR-W
→ Ethernet ports on the 7705 SAR-Wx (all variants)
→ Ethernet ports on the 7705 SAR-H
→ Ethernet ports on the 7705 SAR-Hc
→ Ethernet management port
→ DSL module ports when the module is installed in the 7705 SAR-M (variants
with module slots)
→ GPON module ports when the module is installed in the 7705 SAR-M (variants
with module slots)
→ 2-port 10GigE (Ethernet) module (v-port only) when the module is installed in
the 7705 SAR-M (variants with module slots)
→ GPON interface via SFP in the 7705 SAR-W
• network ports on the 4-port OC3/STM1 Clear Channel Adapter card (POS
encapsulation)
Use the following CLI syntax to configure IPv6 parameters:
CLI Syntax: config>router
interface ip-int-name
ipv6
address ipv6-address/prefix-length
[eui-64]
neighbor ipv6-address mac-address