Alcatel-Lucent 7705 - Removing and Deleting a Filter Policy; Removing a Filter from a Service

Filter Management Tasks
320 7705 SAR OS Router Configuration Guide
Removing and Deleting a Filter Policy
Before you can delete a filter, you must remove the filter association from the applied ingress
and egress SAPs, ingress SDPs, and ingress network interfaces.
You can remove a filter policy and then delete it from the following entities:
• Removing a Filter from a Service
• Removing a Filter from a Network Interface
• Removing a Filter from a Ring Port
• Deleting a Filter
Removing a Filter from a Service
To remove an IP or MAC filter from a VPLS SAP or VPLS SDP (spoke or mesh), use the
first CLI syntax (below). For a VPRN or IES interface SAP or spoke SDP, use the second
CLI syntax:
CLI Syntax: config>service# vpls service-id
sap sap-id
egress
no filter ip ip-filter-id
ingress
no filter [ip ip-filter-id | mac mac-
filter-id]
spoke-sdp sdp-id:vc-id
ingress
no filter [ip ip-filter-id | mac mac-
filter-id]
mesh-sdp sdp-id:vc-id
ingress
no filter [ip ip-filter-id | mac mac-
filter-id]
CLI Syntax: config>service# vprn service-id
interface ip-int-name
sap sap-id
egress
no filter [ip ip-filter-id]
ingress
no filter [ip ip-filter-id]
spoke-sdp sdp-id:vc-id
ingress
no filter