IP Router Command Reference
128 7705 SAR OS Router Configuration Guide
Router Interface Filter Commands
egress
Syntax egress
Context config>router>interface
Description This command enables access to the context to configure egress network filter policies for the IP
interface.
If an egress filter policy is not defined, no filtering is performed.
ingress
Syntax ingress
Context config>router>interface
Description This command enables access to the context to configure ingress network filter policies for the IP
interface.
If an ingress filter policy is not defined, no filtering is performed.
agg-rate-limit
Syntax agg-rate-limit agg-rate [cir cir-rate]
no agg-rate-limit
Context config>router>if>egress
Description This command sets the aggregate rate limits (PIR and CIR) for the VLAN bound to the network
interface once a queue-policy has been assigned. The agg-rate sets the PIR value. The cir-rate sets the
CIR value. On a third-generation (Gen-3) Ethernet adapter card, such as the 6-port Ethernet 10Gbps
Adapter card, only the agg-rate can be set—setting the cir-rate is blocked. For information on adapter
card generations, refer to the “Evolution of Ethernet Adapter Cards, Modules, and Platforms” section
in the 7705 SAR OS Interface Configuration Guide.
The queue-policy command is used to enable and disable network egress per-VLAN shapers on a per-
network-interface basis. If a queue policy has not been assigned, or if the no queue-policy command
is issued, then the VLAN interface defaults to the unshaped mode and the aggregate rate limits are set
to their default values. The agg-rate-limit command is only valid when the VLAN shaper is enabled.
To Next Page
Loading...
