IP Router Configuration
7705 SAR OS Router Configuration Guide 137
mtu
Syntax mtu mtu-bytes
no mtu
Context config>router>router-advertisement>interface
Description This command configures the MTU for the nodes to use when sending packets on the link.
The no form of the command means that the MTU option is not sent in the router advertisement
messages.
Default no mtu
Parameters mtu-bytes — the MTU for the nodes to use when sending packets
Values 1280 to 9212
other-stateful-configuration
Syntax [no] other-stateful-configuration
Context config>router>router-advertisement>interface
Description This command sets the “Other configuration” flag. This flag indicates that DHCPv6lite is available for
autoconfiguration of other (non-address) information such as DNS-related information or information
on other servers in the network. See RFC 3736, Stateless Dynamic Host Configuration Protocol
(DHCP) for IPv6.
Default no other-stateful configuration
prefix
Syntax prefix ipv6-prefix/prefix-length
no prefix
Context config>router>router-advertisement>interface
Description This command configures an IPv6 prefix in the router advertisement messages. To support multiple
IPv6 prefixes, use multiple prefix statements. No prefix is advertised until it is explicitly configured
using prefix statements.
Default n/a
To Next Page
Loading...
