IP Router Configuration
7705 SAR OS Router Configuration Guide 145
The no form of the command removes the IP address assignment. The no form of this command can
only be performed when the IP interface is administratively shut down. Shutting down the IP interface
brings the interface operationally down.
Parameters ip-address — the source IP address to be used by NAT. The ip-address portion of the ip-address
command specifies the IP host address that will be used by the IP interface within the subnet.
This address must be unique within the subnet and specified in dotted-decimal notation.
Values 1.0.0.0 to 223.255.255.255
ip-int-name — the name of the interface to be used by NAT
port
Syntax port port [to port]
no port
Context config>router>zone>nat>pool>entry
Description This command configures the UDP/TCP port or port range. Packets that match NAT policy undergo
network port address translation (NPAT) and are routed to their source UDP/TCP port. Configuring a
UDP/TCP port pool requires an IP-address pool because the 7705 SAR does not support port address
translation (PAT) alone.
The no form of this command deletes the port or port range.
Parameters port — the UDP/TCP port or range of ports to which NPAT is applied
policy
Syntax policy policy-id | policy-name
no policy policy-id
Context config>router>zone
Description This command sets the policy to be used by the security zone to build its NAT matching criteria for
incoming packets.
The no form of this command deletes the specified policy.
Parameters policy-id — the number of the referenced policy
Values 1 to 65535
policy-name — the name of the referenced policy
To Next Page
Loading...
